Bootup problem

[Danny]

Near the battery on your motherboard there should be 3 pins with a jumper over 2 of them. Might say CLR CMOS under it. Lift the jumper off and put it on the 2 other pins. Then after 10 seconds, put the jumper back on the first 2. (diagram below)



i  i  i = 3 pins

__ = jumper


  __
i  i  i  <Before you've touched anything
__
i  i  i  <Put jumper on first 2 pins for 10 seconds    (You know you're doing the right thing if at this point, your computer doesn't start up.)
  __
i  i  i  <Put it back how it was before